I went to start my mill the other day and the keyboard will not respond.
the following error
00396* ND OK
CMOS system options not set
CMOS display type mismatch
KB/ interface error
RUN SETUP UTILITY
PRESS F1 to resume
I press F1 and I get nothing. I did unplug the keyboard and plug in an alternate keyboard same error. Any suggestions will be greatly appreciated. Thank you in advance,
You need To go into your bios and setup some of the lost parameters
Your cmos battery probably going bad if so you will have to do this evertime you start the machine if you dont replace the battery
If your smart you will get the machine booted up And copy all your machine parameters Now before your harddrive goes out
That seems to be the next step with these machines
They are good machines but age is catching up with the pc componets
Last edited by cncbpt; 10-27-2011 at 06:22 PM.