| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-05-2011, 12:52 AM
| |||
| |||
Hi all, Got a Bridgeport Interact II with TNC 151B. We replaced the manual RPM control with a 3-phase inverter. The 0-10V signal was already there so it went really smooth and the RPM can now be controlled from the NC-program. I was really glad also because I would be able to run tapping cycle now, but it was not that easy. The tapping cycle went well until the reverse of the spindle. The spindle reversed but feed was set to F0 and program never was finished. Tried then to program a manual spindle reverse but the same thing happens. As soon as I command M04 it is impossible to get any feed no matter what the program says. Anybody knows if this is controlled by any parameter that could be altered? Best regards Pommac  |
|
| Tags |
| interact ii, no feed, tnc 151 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Okuma mill feed rate jumps to rapid feed | easyguy97 | Okuma | 6 | 12-20-2009 04:14 AM |
| Interact 412 | besc | Bridgeport and Hardinge Mills | 0 | 03-15-2009 05:54 PM |
| interact 4 feed problems | davedoubleu | Bridgeport and Hardinge Mills | 1 | 11-20-2008 06:16 PM |
| Interact 412 | code | Bridgeport and Hardinge Mills | 3 | 02-01-2008 08:36 PM |
| Bridgeport Interact manual feed - why inhibited? | swarf_rat | Bridgeport and Hardinge Mills | 3 | 06-23-2007 03:16 PM |
| | |
Linear Mode
