bridgeport MDI?

[MikeMcTague]

Thanks Gus - so you are saying the CNC Controller will run on 3-Phase 220V from a digital inverter - I wasn't intending to step up the voltage (this is a domestic household 220V single-phase supply, 380V/415V not available).

[gus]

I ran 2 TNC145's off of an old 3 phase motor with a dishwasher motor to start it.

[billsnogo]

I got the limit switches wired up (I think) assuming only two of the three terminals get a connection,


but I can not find out where to wire up the power to the motor, I found a junction box at the back, but the wire nuts already have two wires connected, and can not figure where to hook them up, there is no obvious location I am seeing.


I also found a bundle of four black wires that were all taped up, and remember the previous owner saying there were some that had not been connected when he had them. I want to try and find out where they originally came from. Numbers on them are 12, 13, 14 and I think 15.


Anyone have a wiring diagram for one of these machines?

[billsnogo]

bump