| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-20-2011, 12:44 PM
| |||
| |||
I am beginning to get a lot of errors of "spindle not on" when I hit the start key. Can someone clue me in as to where the problem could be? Where is that sensor located and how does it work? Thanks.  |
|
#2
09-20-2011, 10:28 PM
| |||
| |||
| Piggy back contacts on the spindle forward/reverse contactor? Had one do this. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Proto Trak question | cleve | CNCzone Club House | 2 | 01-17-2012 03:59 AM |
| ez trak question | brinmac | Bridgeport and Hardinge Mills | 1 | 10-06-2010 07:26 AM |
| ez trak | redford1955 | Bridgeport and Hardinge Mills | 1 | 02-22-2010 10:17 PM |
| Bridgeport EZ Trak Flashdisk question: | marx911 | Bridgeport and Hardinge Mills | 4 | 01-29-2010 07:09 PM |
| Question about alarm EZ-trak II | frankc | Bridgeport and Hardinge Mills | 4 | 10-18-2005 12:36 PM |
| | |
Linear Mode
