![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| |||
| |||
How can I identify a DX-32 Mother Board? I would like to purchase a "New" or "Reconditioned" Mother Board for a Bridgeport Explorer. Where can I find one priced reasonably? EMI charges around $800.00. Many Thanks, Bob 989 798 6581 |
|
#2
| |||
| |||
| If it's that same as the one in my late 90's V2XT then it's a FIC VA503+ motherboard. They show up on Ebay every now and then. I bought an extra one few months back for $49 and it included a 233Mhz CPU. Hope that helps. It makes my stomach turn at what EMI wants to charge for a decade old regular run of the mill pc motherboard. |
|
#4
| |||
| |||
| I find that thrift stores and dumpster diving are good sources for these older mother boards. You need a ISA slot for the BMDC. That is what makes finding a new board so hard. Also due to the snails pace clock speed of the BMDC, the clock speed of the mother board has to be low, very low. Another limiting factor. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#6
| |||
| |||
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mother Board Repair | minton | General CNC (Mill and Lathe) Control Software (NC) | 0 | 08-15-2011 08:01 PM |
| Need Help!- CNC Mill- Needs Mother Board | Jim77 | Want To Buy...Need help! | 1 | 02-03-2011 09:33 AM |
| Problem- Deckel NSP 56 Mother Board | newenglandusa | Deckel, Maho, Aciera, Abene Mills | 0 | 10-28-2010 01:48 PM |
| Battery circuit or mother board | chuy | Fanuc | 1 | 02-08-2008 03:31 PM |
| Mother board help | Stu D | Servo Motors and Drives | 0 | 07-28-2006 08:48 AM |