| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-26-2011, 08:59 AM
| |||
| |||
I recently obtained a EZ-TRAX DX machine and am learning/exploring on how to use the machine. The serial number is EZ 1/3-342. I think this is series 1? Anyhow, I would like tomknow how to change some parameters that the machine loadds during start-up. Specifically the units of measure (in or mm) and the Incremetal/absolute parameter. right now, my machine starts up in mm and incremental and I would like it to start up in inches and absolute... Any help would be appreciated!  |
|
#2
08-26-2011, 07:26 PM
| |||
| |||
| Have you tried shutting down in inch and absolute? What version of software? Does it have the cantilevered arm type Z feed? George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is anyone using a Proto Trax MX2 with CAM software? | SolidCAM_13 | Knee Vertical Mills | 2 | 04-06-2011 04:12 PM |
| TRAX TRL 1840SX | nitrain | General Metalwork Discussion | 0 | 04-14-2009 08:51 AM |
| proto trax mx2 | johnalu | Europe Club House | 1 | 11-27-2008 09:00 PM |
| | |
Linear Mode
