Newbie- Trying to Learn CNC

[Getter-Done]

I'm working on making a part on a BridgePort Mill DX-32.
Just for the record I could go to the Manual Mill beside this mill and make it No Problem but I want too learn CNC.

Now what I am trying to do is not working. I dont know where in the code to put a Feed rate in for my 2 1/4 fly cutter.

I have a 2in x 2in x 16in long Square 6061 alum.
I have it in a vice and want to face the top off(Square it up).

Here is what I tried with no tool in Collet Today.

T1;
S200 M3;
G0 X0 Y0 Z0;
G90 G70 G40;
G01 X-20.0 F0.006;
M30;

The mill goes to my start point and rapids the 20inch length.

[geiges]

I have a 2in x 2in x 16in long Square 6061 alum.
I have it in a vice and want to face the top off(Square it up).

Here is what I tried with no tool in Collet Today.

T1;
S200 M3;
G0 X0 Y0 Z0;
G90 G70 G40;
G01 X-20.0 F0.006;
M30;



goo g90 g70 g40;
mo6 t1
s350 mo3;
g43 h1;
goo x0 y0;
z.1;
g01 z0 f4.;
x-20.;
goo z4.;
m30;

try that.

[Getter-Done]

I changed my mind on the Flycutter and used a 1" end mill. Because I need to buy a different tool bit to do that.
I use a G173 code to zig zag and that worked for me.
I will write that down and when I get some bits I try it.

Thanks