| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-16-2011, 09:18 AM
| |||
| |||
Hi everyone, first time doing this on the site, we have a bridgeport eztrak II our monitor went out so we replaced it and now the screen is in the lower right corner how do we adjust the horizontal and vertical hold control  |
|
#2
05-17-2011, 07:40 AM
| |||
| |||
| Sounds more like you have a newer HD monitor that is being fed a VGA signal. Try changing the display on the monitor set up. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
05-17-2011, 08:18 AM
| |||
| |||
| how do you get to the monitor set-up in the system and the numbers on the screen that tell you what buttons to push do not show up on the screen thanks again Last edited by makenparts; 05-17-2011 at 08:42 AM. |
|
#4
05-17-2011, 06:49 PM
| |||
| |||
| You need the book on the monitor. There is not much you can do on the machine motherboard end unless you have a new modern mother board. And then You would have to consult that manual. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Job Opening CNC Machining Center- both Vertical and Horizontal - MI | MachiningJobs | Employment Opportunity | 0 | 04-04-2011 04:49 PM |
| carusel horizontal o vertical | matriceria_fae | Spanish CNCzone | 1 | 08-08-2010 08:30 AM |
| Horizontal / vertical mill How to post ? | vsengineering | Mastercam | 2 | 07-27-2010 02:48 AM |
| kempsmith #4 mill (horizontal/vertical ) | Goldhunter_2 | General Metal Working Machines | 2 | 11-19-2009 03:08 PM |
| Vertical/Horizontal Bandsaw purchase | ChrisJ | General Metalwork Discussion | 3 | 07-21-2007 08:30 AM |
| | |
Linear Mode
