Anilam 1100 control jumps and reboots

[djshop]

I have a 3-axis Anilam 1100 on my Supermax mill. It usually works great and I love how easy it is to use. The computer power supply went bad so I replaced it. It had some difficulty booting up at first which I do not understand because I just changed out the PS. After booting up several times it now boots up and goes into the Main screen fine and I can get to the main CNC Control screen. Just sitting there, after some period of time it suddenly jumps all three axis about .25 to 1" and starts rebooting. It will reboot fine. It has done this repeatedly several times. I have not run a program for fear of disaster but I can jog all axis just fine. Any clues as to what may be causing this?

Thanks so much,

Dave

[toolmanjim]

Sounds like your parameters got messed up. Do you have a back up of them? My mill has done this too and if it sits to long with out being used it will do the same thing and I have to go in and correct the parameters. Good Luck