| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-04-2011, 08:39 PM
| |||
| |||
Hello, I have a Bridgeport series 1 Boss 5 mill that I converted to Servo's using Mach 3 and Gecko drivers. Everything is up and running and I am getting around to tuning the motors and setting the acceleration in Mach 3. What is a reasonable acceleration setting for each axis? I am running 3:1 belt reduction on the X and Y and 2:1 on the Z axis. All axis's are using 5 turns per inch ball screws and I am using Keling 1125 oz in servo's on all axis's with 500 count encoders. The X and Y axis velocity is limited to 90 IPM using a 45,000 kHz kernel speed. Thanks, Mike  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach 2-3 pin&port problem | pislik | DIY-CNC Router Table Machines | 10 | 01-05-2012 02:36 AM |
| rs232 port usb port question | beekeeper | Controller & Computer Solutions | 3 | 09-24-2010 03:36 PM |
| Mach usb/parallel port? | BjdfNtPT | Mach Software (ArtSoft software) | 5 | 05-01-2010 11:05 AM |
| Mach & PCI Parallel Port | JeLC | Mach Software (ArtSoft software) | 7 | 05-28-2009 05:33 AM |
| Bridge Port Clone CNC conversion | happymarius | Employment Opportunity | 0 | 01-21-2007 06:56 PM |
| | |
Linear Mode
