Thumb drive for vmc 760-22 - CNCzone.com-The Largest Machinist Community on the net!

laserh20 · #1 03-11-2011, 08:39 AM

Hey everyone, the guy that works on my laser replaced a floppy drive with a thumb drive. I asked if he could put one in my old VMC760. He put it in and it worked perfectly. If anyone out there is interested in this his email is jeremya@Lasermotioninc.com.

Hope this helps someone who is tired of using floppies

gdwood3rd · #2 03-21-2011, 08:33 AM

Go to Odin, Ltd.'s website (odinltd.net) and fill in the contact form and they will contact you. They handle CalMotion units and are as dirt simple to set up and use.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Learning to design, Rules of thumb tap/die	newbie001	Mechanical Calculations/Engineering Design	3	12-21-2009 10:03 PM
New Control: USB Thumb Drive 'ejecting'?	Donkey Hotey	Haas Mills	35	12-12-2009 05:13 PM
Need Help!- Ubuntu-EMS2 on Thumb Drive?	kb9jlo	LinuxCNC (formerly EMC2)	3	02-06-2008 02:29 PM
Running Programs from USB thumb drive	HelicopterJohn	Haas Mills	16	11-11-2007 03:52 PM
USB Thumb Drive Software	automizer	General CAM Discussion	6	12-29-2005 12:14 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)