Hello, I have a R2E4 series 1 Boss 10 Bridgeport that was working fine for awhile, but now when I turn it on, all the lights on the FMDC and the BSP boards light up, with no blinking. Also all the lights on the controller are lit up, I remember when she was working, not all the lights would come on. We called in a Bridgeport Rep, paid him $500 to take out the boards and reseat some chips, then it worked for 7 hours, then it went tits up again. My CRT doesn't show up either, so I can't see any faults. The light on the EAF does not come on either, so it must be before that. It acts like it is in a reset mode that never does anything. I took out the FMDC, EZIO, and the BSP boards and cleaned them, and pushed on all the chips. but is still doesn't work, can anyone help me please??
Check the power supply. If it is out of spec, it will not work.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)