Need Help!- TNC426 file transfer

[KevinV_MEI]

Creating iso files off line. Sending them to the TNC426 through TNremote program. They have an .i extension. Somehow they are being stripped from about 30k to to 12 bytes. Any thoughts?
I can send the files from before and after to anyone who would like them.

[gus]

What is happening to the program when you look at it?

all my programs are .h, but maybe iso is .I? control is fussy, you cannot vary what it wants there

post a program , maybe it would help

are you getting an error message on either end?

[Bpt Service]

The quickest way to try an isolate problems is to first create a simple short program at the control, then punch(send) that one out to your PC. Now look at that program to see if you can determine what may be the problem. Also try using a slower baud rate. Sometimes characters are dropped when baud rate is quicker. Start out at 2400, then try 4800, then 9600. Good Luck