| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-17-2005, 07:15 PM
| |||
| |||
Can someone please tell me where to get a programming manual for the Boss 5? My new (to me) machine didn't come with one. I do have the maint. and part manuals. Also looking for some good books to read about programming in general. Thanks. _Dave  |
|
#2
07-17-2005, 10:53 PM
| |||
| |||
| Try www.machinemanuals.net He has manuals very reasonable on CDROM. Excellent quality. I have purchased a few maintenance manuals. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
07-18-2005, 10:18 PM
| |||
| |||
| Thank's again. Now where can I find "procom"?-Dave |
|
#4
07-18-2005, 10:56 PM
| |||
| |||
| The same place mentioned above has a RS232 kit that includes a cable and software at a very resonable cost. Take a look. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#5
07-20-2005, 09:20 PM
| |||
| |||
| Can't mind it on their site.-Dave |
| Sponsored Links |
| |
|
#6
07-21-2005, 05:38 AM
| |||
| |||
| Here is an ebay link, to the vendor, that machinemanuals.net has used for their RS232 Kits, with the software. http://stores.ebay.com/RS232-Kit |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
