BPT EZTrak DX2 Boot Issue - CNCzone.com-The Largest Machinist Community on the net!

11-13-2010, 11:02 AM

jmorris@mailmds jmorris@mailmds is offline

Join Date: Sep 2006

Location: USA

Posts: 24

jmorris@mailmds is on a distinguished road

BPT EZTrak DX2 Boot Issue

permalink

I am looking for help with a DX2 that will not boot to the flash disk. This machine was built in 97 and I think it has a PCI flash disk. There is not a traditional HDD on the machine.

We can boot to a DOS floppy and then cannot find a "C:\" drive. The BIOS readout does not show a disk drive as a PCI resource during the boot sequence. We replaced the CMOS battery in 2005 and again today. It still cannot find the flash disk.
Does anyone know the correct settings in BIOS for the Primary Master Disk? Please see the attached photos.

Thank you in advance,
Jon

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TC-22 MB harddrive boot issue	tpmx57	Bridgeport and Hardinge Mills	18	10-03-2010 08:18 AM
EZTrak CRT	md63825	Bridgeport and Hardinge Mills	1	01-23-2008 02:30 PM
EZTRAK DX II	Zombiestomp	Bridgeport and Hardinge Mills	2	01-05-2008 02:10 PM
Help for Eztrak 2	Holzwurm56	Bridgeport and Hardinge Mills	0	11-04-2007 08:55 AM
Help with selector switch wiring issue (*actually a motor issue*)	BEDFORD	Industrial Hobbies (Support forum)	7	04-07-2006 03:19 PM

All times are GMT -5. The time now is 04:31 PM.