| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-12-2010, 09:01 PM
| |||
| |||
I am looking for help with a DX2 that will not boot to the flash disk. This machine was built in 97 and I think it has a PCI flash disk. There is not a traditional HDD on the machine. We can boot to a DOS floppy and then cannot find a "C:\" drive. The BIOS readout does not show a disk drive as a PCI resource during the boot sequence. We replaced the CMOS battery in 2005 and again today. It still cannot find the flash disk. Does anyone know the correct settings in BIOS for the Primary Master Disk? Please see the attached photos. Thank you in advance, Jon  |
|
| Tags |
| bios, bridgeport, dx2, eztrak |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How setting tools and setting offset | John246 | Sharp CNC | 9 | 03-17-2010 09:31 PM |
| Need Help!- Need help setting the kit up! | Crawler374 | Hobbycnc (Products) | 0 | 08-23-2009 03:56 PM |
| Need Help!- Setting Z 0 | ErnieD | Tormach PCNC | 10 | 06-29-2009 08:40 AM |
| Setting up EMC | rmacster | LinuxCNC (formerly EMC2) | 5 | 10-17-2007 08:47 AM |
| Setting z | bbergami | G-Code Programing | 4 | 10-01-2006 08:21 AM |
| | |
Linear Mode
