Remove M06

[oxton]

we have a new (2nd hand) bridgeport with 426/430 control it uses M06 for Toolchanges- i wish to not use M06 ( i.e. Tool Call 2 will get Tool2 without M6)
this will match our other machine with similar control- is there a parameter i can change to do this - thanks

[gus]

yeah yeah, and how do you get it to display the actual z dimension like my other heidenhains do after a tool change. PITA to zero a tool, entering the tool length from the tool table instead of just zero. too many parameters to read through....