Discovery 308 axis drive motor needed - CNCzone.com-The Largest Machinist Community on the net!

hideaway · #1 09-22-2010, 03:34 PM

I have a Bridgeport Discovery 308 with sx 15 control. I need a z axis drive motor or encoder. They are no longer available from Bridgeport or SEM. Does anyone have a used one they would like to sell? It's an SEM type MT 30u431 with a Heidenhain encoder ERO 120-1250. (I broke the glass scale.)

mactec54 · #2 09-22-2010, 03:56 PM

hideaway

We might have that encoder, we will have to check, I know we have some of the different Heidenhain encoders that were for Bridgeport machines

hideaway · #3 09-23-2010, 08:25 AM

Thanks for checking!

mactec54 · #4 09-23-2010, 11:38 AM

hideaway

Can you post a photo of you motor encoder

mactec54 · #5 09-23-2010, 11:52 AM

hideaway

Just sent PM we have 2 compleate new unused motors

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
92 Bridgeport Discovery 308 Drive circuit board WANTED	Richardd	Bridgeport and Hardinge Mills	2	04-14-2011 06:28 PM
Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface.	kreutz	Stepper Motors and Drives	3	07-03-2008 06:57 PM
Bridgeport Discovery 308 W/SX-15 Control Start up disk needed	Richardd	Bridgeport and Hardinge Mills	1	07-10-2006 08:07 AM
Discovery 300 inverter drive problems	tenmetalman	Bridgeport and Hardinge Mills	3	04-07-2006 04:19 PM
Massive 5-axis on Discovery!	svenakela	CNCzone Club House	1	08-05-2004 07:42 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)