Adding a power drawbar - CNCzone.com-The Largest Machinist Community on the net!

07-29-2010, 01:30 PM

ErnieD

Join Date: Aug 2005

Location: USA

Age: 78

Posts: 197

Adding a power drawbar

permalink

Hi,

I have a Bridgeport EZTRAK SX. I recently bought a used Acer model 30 air power draw bar unit. I am going to adapt it to my Bridgeport and I am wondering if anyone has done this. My reason for asking is to save time. I have a draw bar but the spline is too small for the Acer unit. I can make a new spline to fit the draw bar. Any comments?

Thanks,

Ernie

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
power drawbar now available	syil canada	Videos	0	03-16-2010 11:52 AM
DIY Power Drawbar	bgolash	Benchtop Machines	19	08-14-2009 04:40 PM
Power Drawbar Anyone?	gleas	Novakon Systems	7	07-19-2009 07:34 PM
Power drawbar	Bigbloke	Bridgeport and Hardinge Mills	1	03-14-2009 07:36 AM
Need Help!- Adding an X axis power feed to my smithy 1220XL milling table.Adding an X axis power	matridium	Smithy	0	05-28-2008 10:37 AM

All times are GMT -5. The time now is 04:21 PM.