Need Help! Bridgeport DX32 Programming - CNCzone.com-The Largest Machinist Community on the net!

minton · #1 07-22-2010, 11:55 PM

I need help programming a Bridgeport 3 Axis CNC with a BOSS DX-32 Control.

Is there some user friendly software that would figure the geometry and end point coordinates in lieu of doing all of the trig.

Your help would be greatly appreciated.

Regards,

Bob Adams
989 798 6581

fredhh47 · #2 07-23-2010, 08:06 AM

Bridgeport EZ-CAM is very user friendly. I have used it for about 25 years. You can find several versions of it available, I like Version 6. They spun off into a separate company after Bridgeport went bust. I believe they still call it EZCAM software, and are above version 13. The older versions were very stable and easy to use, I have no experience with anything aboive V6. You can also get a free trial version of several packages, like BobCad and try them out. Try Googling things like "CNC programming software"

minton · #3 07-23-2010, 09:21 AM

fredhh47:
Thanks for your reply. I would like to purchase this program...if I can find one. Also, I would like to have your name and phone number for further discussion. Please send it to rwadams1@aol.com.

Regards,

Bob Adams
989 798 6581

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- DX32 Programming HELP	minton	Controller & Computer Solutions	2	03-01-2011 05:44 PM
Need Help!- Bridgeport Explorer I Boss DX32	minton	Bridgeport and Hardinge Mills	2	02-15-2009 09:11 PM
Bridgeport DX32 post	Chris Rand	Post Processor Files	2	11-19-2008 04:27 PM
Need Help!- 1997 Bridgeport VMC800 DX32	pbrtoolmaker	Bridgeport and Hardinge Mills	1	10-26-2008 08:39 AM
need Bridgeport discovery DX32 programming help	dfelice	Bridgeport and Hardinge Mills	8	07-17-2007 09:24 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)