| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-09-2010, 08:32 PM
| |||
| |||
I turned on My V2XT this morning and I got a black screen with "Enter current password" I have never seen this before and I have no idea what to do. I get three tries and then I get a locked out. Help! It is a 1997 DX32 control. I have no boot disk. Dan  |
|
#2
07-09-2010, 09:13 PM
| |||
| |||
| What I believe happened is that the CMOS got screwed up. That is the only place that you could be confronted with a password. to clear it you need the book on the mother board showing the jumper to clear the MOS and with it the password. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- ladder locked out BP 412 Fanun 0-MF | eng101 | Bridgeport and Hardinge Mills | 18 | 03-26-2012 04:40 PM |
| Need Help!- locked out of my fadal | sec1964 | Fadal | 2 | 03-23-2009 03:19 PM |
| Stepper motor locked up | jeffmorris | DIY-CNC Router Table Machines | 4 | 08-29-2008 02:40 PM |
| locked programs | stevo1 | Fanuc | 0 | 07-09-2008 11:11 AM |
| | |
Linear Mode
