V2XT Software - CNCzone.com-The Largest Machinist Community on the net!

harrismachines · #1 06-10-2010, 11:41 AM

I have a V2Xt that I have replaced the motherboard and hard drive with a "disc on module" from EMI. The machine runs great, but I need the enhanced performance software that runs the mouse and Renishaw probe. Does anyone know where this software can be found?

machintek · #2 06-11-2010, 06:38 AM

The enhanced performance option included win3.1 and solid modeling. The windows ran the mouse. There was also a disk that installed BAT files that enabled the F keys to load windows. I always left these disks with the customer. They were his property.
Never installed a probe on a V2XT but I assume these files were from Renishaw. Check with them.

George

harrismachines · #3 06-11-2010, 08:17 AM

Thanks, George. I checked with Renishaw. They said Bridgeport had the software and could not help me. These discs are what I am looking for. I am trying to locate the guy I bought the machine from three years ago.

Thanks again,
Kieth

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Bridgeport V2XT	nate1352	Bridgeport and Hardinge Mills	0	07-10-2009 03:23 PM
V2XT with a New BUG up its A$$ !! Again...	v488	Bridgeport and Hardinge Mills	2	05-26-2008 01:55 PM
Bridgeport series I V2XT software issue?	biggs	CNCzone Club House	0	05-17-2008 08:00 PM
V2XT Software Startup	cncnavy	Bridgeport and Hardinge Mills	8	02-17-2007 04:31 PM
v2xt problems	mikebryner79	Bridgeport and Hardinge Mills	3	09-30-2006 10:49 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)