Results 1 to 1 of 1

Thread: Torq cut 22. axis power supply failure,low voltage

  1. 06-03-2010, 09:00 PM #1
    Dirtman
    Dirtman is offline
    Registered
    Join Date
    Jul 2008
    Location
    US
    Posts
    5
    Downloads
    0
    Uploads
    0

    Torq cut 22. axis power supply failure,low voltage

    I have this error. The power at the breaker in front of the capacitor is 110 volts at each of the 2 legs but maybe 2 volts comming out. Is thr capacitor
    bad?
    Last edited by Dirtman; 06-03-2010 at 09:16 PM.

« Torq cut 22 | BTC-1 retro fit using DSPMC/IP controller. »

Similar Threads

  1. Need Help!- Cincinnati Milacron Acramatic 2100 Power Supply Failure error
    By Wurmwood in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 5
    Last Post: 03-17-2012, 02:53 PM
  2. Problem- BMC20 Low Voltage Power Supply
    By Rally in forum HURCO
    Replies: 0
    Last Post: 08-06-2009, 06:28 AM
  3. Need Help!- Power supply failure
    By Aiman Ebraheem in forum General Electronics Discussion
    Replies: 1
    Last Post: 03-02-2009, 09:40 AM
  4. X2 Minimill Power Supply Failure
    By ozsteamdemon in forum Australia, New Zealand Club house
    Replies: 8
    Last Post: 12-08-2008, 02:11 AM
  5. Haas VF-3 servo distribution power supply failure
    By Drkk in forum Haas Mills
    Replies: 0
    Last Post: 12-03-2006, 10:48 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.