Torq cut 22. axis power supply failure,low voltage - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > MetalWorking Machines > Bridgeport and Hardinge Mills
Torq cut 22. axis power supply failure,low voltage

Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here!

This forum is sponsored by:

06-03-2010, 08:00 PM

Dirtman

Join Date: Jul 2008

Location: US

Posts: 5

Torq cut 22. axis power supply failure,low voltage

permalink

I have this error. The power at the breaker in front of the capacitor is 110 volts at each of the 2 legs but maybe 2 volts comming out. Is thr capacitor
bad?

Last edited by Dirtman; 06-03-2010 at 08:16 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Cincinnati Milacron Acramatic 2100 Power Supply Failure error	Wurmwood	General CNC (Mill and Lathe) Control Software (NC)	5	03-17-2012 01:53 PM
Problem- BMC20 Low Voltage Power Supply	Rally	HURCO	0	08-06-2009 05:28 AM
Need Help!- Power supply failure	Aiman Ebraheem	General Electronics Discussion	1	03-02-2009 08:40 AM
X2 Minimill Power Supply Failure	ozsteamdemon	Australia, New Zealand Club house	8	12-08-2008 01:11 AM
Haas VF-3 servo distribution power supply failure	Drkk	Haas Mills	0	12-03-2006 09:48 PM

All times are GMT -5. The time now is 04:16 PM.