| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-26-2010, 09:32 AM
| |||
| |||
Suggestions on clearing "DSP Fault - DSP interup failed" I'm the office guy trying to help the machinist. Thank you.  |
|
#2
05-26-2010, 09:52 PM
| ||||
| ||||
Make sure the estop button isnt depressed, hit clear on control. If possible jog one axis at a time and see which one causes it. This error means that there was a connection lost some where in the system. this system is in a loop. i would check the cables coming from the motors for kinks or tears in the cords. possible a connector is loose? if not one of the motors are bad. cables are part of the motor. I would also try moving the axis's and see if the dro display changes as you manually move that axis.... hope that helps!! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Acu-Rite MillPwr Problems | Tazzer | Bridgeport and Hardinge Mills | 6 | 03-08-2011 04:25 PM |
| Acu-Right Millpwr | Tazzer | Post Processor Files | 7 | 01-14-2009 02:24 PM |
| Acu-rite Millpwr | CRAZYRICH | CNCzone Club House | 2 | 01-27-2007 02:13 PM |
| Acu-rite Millpwr | bybon | Bridgeport and Hardinge Mills | 1 | 09-18-2006 08:51 PM |
| MillPwr | ddwiers | General CAM Discussion | 1 | 12-31-2005 01:37 PM |
| | |
MILLPWR, ACU-RITE 
Linear Mode
