| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-17-2010, 06:50 PM
| |||
| |||
I have access to a CNC which hasn't been run for a while. It has a 25 pin connector for a PC connection but that is as much as I know. The owner is cautious and hasn’t turned it on to see if it works because his 3-phase source has one leg slightly higher than 220 V and is concerned with the “control” circuit if that leg happens to feed the control transformer. I don’t have a schematic so I am running blind. Where can we get some help?[  |
|
#2
04-18-2010, 12:02 PM
| |||
| |||
| Never heard of this machine. Please be more specific. How old is it? Take a picture and attach it here. George
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport J1 | andrewbooker | Bridgeport and Hardinge Mills | 3 | 02-26-2010 08:39 PM |
| Bridgeport DNC | hmc710 | Bridgeport and Hardinge Mills | 9 | 02-08-2010 06:14 PM |
| Bridgeport Help Please | pofo | Bridgeport and Hardinge Mills | 8 | 11-11-2009 05:37 PM |
| Which Bridgeport would you buy? | Skyshark | Bridgeport and Hardinge Mills | 2 | 08-17-2007 11:32 PM |
| Used Bridgeport - What to look for? | smird | Bridgeport and Hardinge Mills | 11 | 04-17-2005 10:45 AM |
| | |
Linear Mode
