| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Bridgeport and Hardinge Mills Discuss Bridgeport and Hardinge Mills here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-08-2010, 12:05 PM
| |||
| |||
i have an interact 1 series 2 with qc30 toolholdig. during machining the toolholders are working loose and i have purchased 2 new tool holders and a new lock ring as advised but still have the same problem ! any ideas anyone?  |
|
#2
03-08-2010, 12:11 PM
| |||
| |||
| I would remove the keys temporarily, and apply prussian blue to the tool holder. Place the tool holder into spindle and twist slightly to show if there are any high spots or other problems that would require re-grinding the spindle. SM |
|
#4
03-13-2010, 05:00 PM
| |||
| |||
| You can't tighten them by hand. You need to use a spanner wrench. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toolholding for small drills | fpworks | General Metalwork Discussion | 9 | 11-30-2007 07:49 PM |
| | |
Linear Mode
