Issue was resolved by setting the TAPE/DNC setting to ON. This page was located in the Operators Panel
I have a Bridgeport Interact 412 with a Fanuc Series 0 Mate M controller.
Can you tell me how to put this into drip feed mode? I have included a picture of the controller.
I have looked around on the various pages and soft controls but nothing is jumping out at me.
I can run small programs on the machine but it runs out of memory if I try to load any larger program.
Thanks
Kevin
Similar Threads:
Issue was resolved by setting the TAPE/DNC setting to ON. This page was located in the Operators Panel