Fanuc Controller in Drip Feed Mode

[CastleWorks]

I have a Bridgeport Interact 412 with a Fanuc Series 0 Mate M controller.

Can you tell me how to put this into drip feed mode? I have included a picture of the controller.

I have looked around on the various pages and soft controls but nothing is jumping out at me.

I can run small programs on the machine but it runs out of memory if I try to load any larger program.

Thanks

Kevin

Similar Threads:

• Need Help!- Drip feed mode with Fanuc OMA
• Problem- Drip feed mode for Mazak M32
• Newbie- Drip Feed to a Kiwa Colt Fanuc O-M controller
• Drip Feed into a Fanuc 11MA Controller on Bridgeport R2G4 V Mill
• Drip feed mode for FANUC-6M

[CastleWorks]

Issue was resolved by setting the TAPE/DNC setting to ON. This page was located in the Operators Panel