Torq Cut 22 Servo Amplifier Communication


Results 1 to 4 of 4

Thread: Torq Cut 22 Servo Amplifier Communication

  1. #1
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    521
    Downloads
    0
    Uploads
    0

    Default Torq Cut 22 Servo Amplifier Communication

    Hoping MacTec chimes in but....
    Does anyone know how the BMDC board communicates with the servo amplifiers? Is it a proprietary protocol or is it standard analog +/-10V?
    I'm talking about the mid 90's machines with DC Brush Servos

    Similar Threads:


  2. #2
    Member mactec54's Avatar
    Join Date
    Jan 2005
    Location
    USA
    Posts
    15362
    Downloads
    0
    Uploads
    0

    Default Re: Torq Cut 22 Servo Amplifier Communication

    Quote Originally Posted by Marty_Escarcega View Post
    Hoping MacTec chimes in but....
    Does anyone know how the BMDC board communicates with the servo amplifiers? Is it a proprietary protocol or is it standard analog +/-10V?
    I'm talking about the mid 90's machines with DC Brush Servos
    Just the normal standard +/-10v well all the TC1 Etc do but they have AC servos, I don't think the BMDC boards are very different from the TC22 to the TC1 Etc, may have some different onboard software changes, some of the machine parameters are different that's about it

    Mactec54


  3. #3
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    521
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by mactec54 View Post
    Just the normal standard +/-10v well all the TC1 Etc do but they have AC servos, I don't think the BMDC boards are very different from the TC22 to the TC1 Etc, may have some different onboard software changes, some of the machine parameters are different that's about it
    Thanks. It would be great if they did use standard analog input, but I vaguely remember reading somewhere that the DC Brush drives for the Today Cur 22/30 were proprietary to Bridgeport?
    Are there schematics/pin outs out there in the wild for them to verify?

    Marty



  4. #4
    Member mactec54's Avatar
    Join Date
    Jan 2005
    Location
    USA
    Posts
    15362
    Downloads
    0
    Uploads
    0

    Default Re: Torq Cut 22 Servo Amplifier Communication

    Quote Originally Posted by Marty_Escarcega View Post
    Thanks. It would be great if they did use standard analog input, but I vaguely remember reading somewhere that the DC Brush drives for the Today Cur 22/30 were proprietary to Bridgeport?
    Are there schematics/pin outs out there in the wild for them to verify?

    Marty
    A lot of Bridgeport parts are propriety to them, just as any other manufacture of machines of all kinds, those old drive are for sure, as there was not much choice back when they where built, most manufacturers made designed and manufactured there own parts, just as some still do, Haas being a great example of that

    Mactec54


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Torq Cut 22 Servo Amplifier Communication

Torq Cut 22 Servo Amplifier Communication