SEM servo repair/replace


Results 1 to 1 of 1

Thread: SEM servo repair/replace

  1. #1
    Member
    Join Date
    Mar 2011
    Location
    brooklyn park, MN
    Posts
    273
    Downloads
    0
    Uploads
    0

    Default SEM servo repair/replace

    Looks like I did some damage to one of my servo's while tuning. I let it oscillate too long and it started smoking. Now it smells burnt and when I turn the shaft it turns freely except in one spot where it is very hard to turn once it gets to that point. I assume that is the area it kept oscillating at. Anyone know how much to repair something like this, what is most likely damaged, can it be repaired? It is the SEM MT30H4-44 model. There are several models on ebay ,none that are the same as mine.

    thanks guys/gals

    Similar Threads:
    Last edited by billsnogo; 05-25-2015 at 09:47 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

SEM servo repair/replace

SEM servo repair/replace