At the time I was working on it I was trying to create a program to load the tool carousel, which looks like this according to my manuals.
O0001;
T0 M06;
M30;
I had that program, but it kept throwing an error code 78 when I tried to run it, which is defined as: A program number or a sequence number which was specified by address P in the block which includes an M98, M99, M65 or G66 was not found
I need to figure out what I'm doing wrong here so I can load the tool carousel.
I may be able to get the parameters from the machine shop I bought the machine from or they may be able to tell me where to get them from.