Make sure emergency stop is not pushed in when control is turned on.
Otherwise check 24VDC power supply.
George
hi all please help me here. i m founding the error in tnc 351 control
relay ext dc voltage missing.
shabbir mughal
Similar Threads:
Make sure emergency stop is not pushed in when control is turned on.
Otherwise check 24VDC power supply.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for reply
i have cleared this error . y hardware limit switch was pressed and creating this error.
but now servo is not turninging on. now i m finding why servo power supply contector is not turrning on?
thanks
shabbir mughal