- Newbie- Need BOBCAD V24 Post Processor for Haas VF-2
-
Registered
Need BOBCAD V24 Post Processor for Haas VF-2
looking for a post processor for my Haas VF-2D, learning BobCAD V24. Also a Centroid M400 post wouldn't hurt either
Similar Threads:
-
-
Member
Re: Need BOBCAD V24 Post Processor for Haas VF-2
What's the "D" stand for ?
-
Member
Re: Need BOBCAD V24 Post Processor for Haas VF-2
Here is one I used for V25 for a Haas VF-2
-
Registered
Re: Need BOBCAD V24 Post Processor for Haas VF-2
thanks, will give it a go and update. The "D" might be revision D of the VF-2, maybe?
-
Registered
Re: Need BOBCAD V24 Post Processor for Haas VF-2
The D would usually be a certain equipment package/configuration version.....
If you can't get a post, shoot me a message and I'll find one on the old confuser.
-
Member
Re: Need BOBCAD V24 Post Processor for Haas VF-2
-
Registered
Re: Need BOBCAD V24 Post Processor for Haas VF-2
thanks for the support guys. its going slow, these are new waters here.
- Newbie- Need BOBCAD V24 Post Processor for Haas VF-2
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules