Not working

[mmachining]

Hey guys, I have a part that I have ran in the past from version 21. Know I am redoing it and its been awhile since I have done anything on version 21. This part was from a email from a customer, If I draw something from the start it works fine. Do I need to adjust something because it was not drawn in bobcad? Other question is why when I generate tool path, all I get is x,y, G0, and G1 nothing else. Where there should be lines of code all I get is the N line # like this-

N82044 Z1.5173
N82046 There sould be some something here????
N82048
N82050
N82052 Z1.3816
N82054
N82056
N82058 Z1.2698
N82060 Z1.1603
N82062 X-1.7725
N82064 Z1.0537
N82066
N82068F3.
N82070 G00 X-1.5209 Z1.9237
N82072 G01 Z1.8129F40.
N82074 Z1.694
N82076 Z1.5756
N82078
N82080 G00
Any help would be great. Thanks.
__________________

[harryn]

Hi - just trying to reach you. PM sent.

HarryN

[Swag]

Do I need to adjust something because it was not drawn in bobcad? Other question is why when I generate tool path, all I get is x,y, G0, and G1

Any help would be great. Thanks.
__________________

Try a different post, it looks like you are using a lathe post ( assuming this is a mill part), I only see X & Z moves, I didn't see any Y moves in your G code