More crop circles, and turning question

[seanreit]

www.my87.com/cnc

my bobcad file and my nc file.

I want to use mach3 turn, I can not get the crop circles to go away.

also, when I do macro program start, it puts in x8 and z8 by default, how do I change that to go to x1 z1 as I have corrected manually in the nc file attached.

thanks for the help, I'm going nuts!

[The One]

Which version are you using?

Regards

[seanreit]

latest, 21.5.2 (well, latest prior to 22)

[The One]

Can you post a sample program? I bet it is something that is totally obscure, and only evident in the code.

Regards

[seanreit]

It's in the first post of this thread, I listed the text file and the drawing. I have put every crop circle suggestion mentioned on this site, mach3 support, and the bobcadsupport forum into effect. No changes for the better, in fact crop circles got worse.

I have had to erase all g3 and g2 commands out of the text file. Thattakes a lot of time.

[The One]

I can see the code, but I cant get the dwg file. It back plots just fine in Predator and in BobCAD. Is your Mach software set up for I and J values or for Rs?

Regards

[seanreit]

thats a good question, how do I tell?

[The One]

Honestly, it has been at least a yeat since I looked at the Mach3 control panel. But there may be some one here who can tell you how to find that out.

Regards

[seanreit]

All I could find was swapping IJ Mode, from incremental to absolute, which did nothing for me.