Need Help!- Need Post-Bobcad V22 to Fanuc 10M Mill

[steppshann]

Have BobCad V22 and unable to get a post for a milling machine with a Fanuc 10M Controller. If you can help please contact me. Thanks for any help.

[MikeTheG]

have you tried the website , if so then send bobcad a post request form from the website and they will make one for you.

[steppshann]

Thanks for the reply Mike, I have done all of the above and am still waiting. They said that they have sent me a post that works but it doesn't and I am getting bad vibes from them when I talk to them. So far no good results. I would save time if I could find a reasonable cost to write a post. I am starting to feel like this.

[smurph]

If you have filled out a post request and given them all that they asked for, then stay on them about it. Talk to Scott Phillips. He will get you what you need.

Steve

[Sowen]

What is not working ? DO you get an error when you send the program . Fanuc is pretty standard Its probably just a single code issue , if you post a simple program here and which line the machine errors on , I could fix it for you. Or just email bobcad with the program that does not run and the error that your machine generates.