| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| BobCad-Cam Discuss all BobCad software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-01-2004, 03:00 PM
| |||
| |||
| BobCad and FET3 from Stepperworld Hi, Can anyone tell me if BobCAD can communicate with the FET3 controller from stepperworld? The software documentation talks about RS232 interface, but nothing about setting it up through the parallel port (which is what the FET3 uses). Do I need a special postprocessor to make it work? Thanks for any help, Mike    |
|
#2
09-01-2004, 04:13 PM
| ||||
| ||||
| No, BobCAD will create g-code. You need a machine controller like Mach2 or TurboCNC to run your FET.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
