| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| BobCad-Cam Discuss all BobCad software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-21-2008, 06:24 PM
| |||
| |||
| V22 - Ramping available? (versus plunge) Does anyone in V22 have the ability to "ramp" into pockets instead of just plunging? I have a "ramp" button, but it is grayed out - implying that it is not available for anyone or that it's an additional cost. My version is the "full" v22 versus but does not include the equidistant offset for waterline milling.
__________________ Tormach PCNC 1100, SprutCAM, Alibre CAD    |
|
#2
04-21-2008, 10:40 PM
| |||
| |||
| You need to put a point in the pocket and select it the same way you do the geometry before you can use the ramp. John Last edited by COMMAND JOHN; 04-21-2008 at 11:20 PM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ramping on a arc | binzer | GibbsCAM | 7 | 06-10-2008 09:38 PM |
| Feed/speed for plunge or ramping | mrk | General Metalwork Discussion | 7 | 08-13-2007 12:33 PM |
| Mister versus flood versus ??? coolant system | split63 | Bridgeport and Hardinge Mills | 14 | 10-02-2006 06:18 AM |
| Ramping | pauls | BobCad-Cam | 1 | 03-04-2005 04:49 PM |
| Ramping example? | inthedark | G-Code Programing | 5 | 04-10-2004 09:53 AM |
| | |
Linear Mode
