Newbie Post Processor Problems - CNCzone.com-The Largest Machinist Community on the net!

krz2_2000 · #1 02-28-2008, 09:46 AM

I can't seem to get ant post processors to work for me. I have an old Bridgeport Mill with a Dyno-motion controller. All of the post processors output a subprogram. I can get close by editing but I still not right. I don't know what to do next. I'm pretty new to this. Any help would be appreciated.

ejdfast · #2 02-28-2008, 10:33 AM

Right click on milling tools then go to current settings then click on posting and uncheck output subprograms

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post Processor Problems	lt1pat	FeatureCAM CAD/CAM	4	04-11-2006 05:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)