Need Help!- Lost G41/G42 in pocketing in V22

[seal1966]

I did a pocket program about a week ago with Bobcad, and it output a G41/G42 on the finish endmill as a wear offset. I did a pocket program yesterday, and I can not get it to post the G41/G42 on the finish endmill. How do I get it back, what am I doing wrong?

I have build 861, and when it work may have been the previous build.

Please Help.
Fred

[The One]

Are you doing a lead in/out into your finish operation? the system will typically not allow you to activate cutter comp on the profile itself, but instead requires a lead in/out to see the output.

Regards

[seal1966]

I was using pocket in two different operation in the program. The first spot I used vertical, the second, I used circular lead. I did try changing the first to a circular, and it did not make a different.

Fred

[The One]

Can you post the file? That would help determine where the problem is happening.

Regards

[seal1966]

Here the file, I hope it help.

Fred