Problem installing Bobcad 2007 on Vista

[CNCadmin]

I tried to install Bobcad 2007 and it just hangs on the install, any ideas what the problem is?

[The One]

What OS are you using?

How long did you let it go and did you end it?

Regards

[CNCadmin]

Nevermind all is well

[ejdfast]

Please call Bobcad tech support and they will help you with the install

[CNCadmin]

This was MY bad, I did not wait long enough, and thought the program was hanging.

[tjones]

Cheap laptop with Vista basic...installed no trouble at all! Yes it was about as cheap as it gets Walmart purchased Acer. 1.73 ghz 1.5 gig ram (added extra).

Dongle worked.

But first. Removed NIS and installed AVG. Turned off that stupid security pain with all the popups asking if I really want to do what I just right clicked and told to run as administrator (stupid MS.. if I didn't want to do then I wouldn't have gone through the trouble of all that).

No problem of any the kind.

Oh yes...and the ramp in the pocket worked too (not sure why someone says there are no ramping at all since I just did one).