| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| BobCad-Cam Discuss all BobCad software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-17-2007, 01:43 PM
| |||
| |||
I have a part that is a little more than I can handle. I have a 3 axis router and v21 software. The part is an abdominal support for massage chairs and looks like a section of a donut 2.5" tall, and about 9"od radius and 8" inside radius. It is about a quarter of the whole circle with angled ends from bottom to top. I can email drawings if someone could help me brainstorm the easiest way to finish the drawing in a way that would allow the software to generate the toolpath most efficiently. Thanks for any help.  |
|
#3
10-22-2007, 03:16 PM
| ||||
| ||||
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toolpath set up? | Jessica | ArtCam Pro | 5 | 03-13-2007 11:13 AM |
| 3D toolpath help | Dfennell | BobCad-Cam | 2 | 02-03-2007 01:13 AM |
| Project Toolpath on STL | Sanghera | Mastercam | 7 | 03-12-2006 06:43 PM |
| V19 incorrect toolpath | Castle1 | BobCad-Cam | 2 | 07-02-2004 10:10 PM |
| Need help with toolpath control | Pappy | General CAM Discussion | 4 | 01-23-2004 05:29 PM |
| | |
Linear Mode
