2007 pocket/island

[marty7001]

I am having trouble with pocketing a simple island with V2007. It cuts the pocket too large when not using zig-zag. I have tried all combinations of rough/finish or no finish; profiling before, after, or not at all; pocket offset in or out; and different amounts of side allowance. What am I missing here? I am sure that it is something simple that I am overlooking.

Thanks to all
Marty

[The One]

Can you post the file? It sounds like it may be related to cutter comp, but will only be able to tell for sure if you post the file.

Regards

[marty7001]

What file format do I use? Do you want the coded file or the drawing?

Marty

[tobyaxis]

Originally Posted by marty7001 What file format do I use? Do you want the coded file or the drawing? Marty

I had a few problems with the Pocketing in V2007. I will be sending the file to Tech Support soon.

Can you post both files Code and Drawing? It will be best to Zip it so the site will accept it.

[marty7001]

I think I have the files hee. If not, let me know.

Thanks for the help.
Marty

[The One]

You password protected the file! Can you PM the password?


Regards

[marty7001]

'TheOne'
Did you get the password?

Marty

[The One]

Yes, I got it and I have reviewed the file and the issue that you are having. You were right, there is an issue there. This should be handled in the next update. You should see this update early next week or possibly even tomorrow. It is more than likely going to be released next week though.

Regards