Leaving tabs on small parts - CNCzone.com-The Largest Machinist Community on the net!

thunterman · #1 12-21-2006, 08:38 AM

I have been using BobCad V21 for awhile now. I am still learning this CAD/CAM. I would like to cut some small parts (wood) without them being sucked into my dust collector. I would like to leave small tabs (bridges) on the parts so that I can then cut them with a knife. Is there an option in BobCad for doing this? I know how to use the "break" option, but this is tedious.

Thunterman

MikeTheG · #2 12-21-2006, 11:17 AM

unfortunatly there is no tabbing function in bobcad you would have to manually create the breaks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)