bobcad to fanuc 3m

[Gpestarters]

I have a question i have a fanuc 3m machine and bob cad v 21 can somebody give some info on pin hook up and the baud rate on this old fanuc machine thanks tony gpestarters@coxinet.net

[tobyaxis]

I replyed to your other post. Here is the Link

http://www.cnczone.com/forums/showthread.php?t=22770

[Gpestarters]

Thank you for the help it has help some if you have anymore info i would appreciate it thank you Tony

[tobyaxis]

I took the liberty of posting a thread for you in the BCC forum. This will get someones attention

Here is the Link

http://216.117.147.20/bobcadsupport/...=9918#post9918

[lakeside]

the bird put this link up from bobcad site at tobyaxis request http://216.117.147.20/bobcadsupport/...read.php?t=799

[tobyaxis]

Originally Posted by lakeside the bird put this link up from bobcad site at tobyaxis request http://216.117.147.20/bobcadsupport/...read.php?t=799

Thanks for the Post Mike

[tobyaxis]

Originally Posted by Gpestarters I have a question i have a fanuc 3m machine and bob cad v 21 can somebody give some info on pin hook up and the baud rate on this old fanuc machine thanks tony gpestarters@coxinet.net

Sent you the email

[Gpestarters]

I Think i am Going To Repharse My Question i Think i Have The pin location Right Now I Dont Think Iam In tHe Right area In the Fanuc 3M Machine I think? Are you supposed to Be in The Edit Section For Of The MDI Section To Recieve My Data If Anybody Can Help I would Appreciate ThAnks tony. Gpestarters@coxinet.net

[tobyaxis]

You have to be in edit mode on the program page last I used a Fanuc control. Been using Mazak, Acromatic, and Haas lately. Does your machine control have a CRT or X Y Z digital readout. Some of the older machines are like this. This are a huge PITA.

[Gpestarters]

We Have a CRT And We Have been Doing It In The Edit side But It Just Dont Seem To Be responDing Or Taking info Thanks tony

[tobyaxis]

Put control in Edit Mode, then use the scrole keys Left/Right on out sides of the CRT. Find a window in which you can enter a program Number (O0001) and look for Punch or Read. It has to be there somewhere at the Bottom of the CRT Screen. Can you post a picture of the control for me to see. It will aid me in helping you. Like I said before it has been a while. Also Look for a Hard Key with the word "TAPE" above it. Your machine more than likely has an old Tape Reader. The Word "Tape" represents the Program.

[lakeside]

in program # first is letter "O" not a zero it should look like O0001