Burn Table Lead Out of Zero ERROR

[JINDA]

I wanted a Lead Out of 0.00 which shoud be fine.
Bobcad doesn't see it as a Lead Out of 0.00 it
see it as NO LEAD OUT. Which in turn doesn't turn of the gas
and cuts a line in the part and turns it to scrap.

This is an ERROR or there should be a NOTE: Lead Out of 0.00
will etc...



Later JeReMy

[aldepoalo]

JINDA,

What post are you using? I get a "m code " for off and on if I use a lead in / out or just a lead in...

Can you post a sample file and or your post processor?

Al

[JINDA]

Thanks Got it.
The error is in the post


Later JeReMy