How to Change Predator to simulate canned cyles in Lathe- Fanuc

[Kenneth434]

Please help!! Need help changing Predator so it will simulate canned cycles on Fanuc 10T. Anyone had any luck with this?

Thanks,

Ken

[Kenneth434]

Had some luck modifying the rpl. file for 10TA and able to get it to rough OD correctly but will not simulate face in canned or simulate G76 threading. Also will not simulate a finish cycle in separate moves after a canned cycle. Any help will be apprecated!

[Kenneth434]

I'm working with V24. I've attached the post and Predator rpl. file I'm using. I could only figure out how to upload them in txt. form. Any help will really be appreciated!

[Kenneth434]

1