Bobcam V24 stock help!

[kawman]

I am cutting the whole part using EquiDistant Offset, and my stock has .02 extra in the Z, I tried setting " Z top of stock" in milling stock to .02, but it still would not post with an extra .02 in Z depth, i set all the tools off the top of my work, and the part is drawn with Z 0.0 being the top surface, Any help would be MUCH appreciated.


if i did not give enough info, let me know and I will try to be more clear, im sure this is some silly little thing i am overlooking.

[BurrMan]

You want your toolpath to post out as if it were somewhere different than where it is? Setting stock heights will have rapids and feeds avoid at the set level, but the cuts will happen where the surface is (May be different for 2d or 3d)

Can you post your bbcd file to discuss it?