Recutting a part

[BurrMan]

Thought we would recut a part to test out some of the new toolpaths. This one used the Advanced roughing to remove most of the material. We were pretty happy with it.



This is the model being cut. Still waiting for my brother to get me the finished part for some pictures of the final result. I'll post it here when i get it.

[The Engine Guy]

Thought we would recut a part to test out some of the new toolpaths. This one used the Advanced roughing to remove most of the material. We were pretty happy with it.



This is the model being cut. Still waiting for my brother to get me the finished part for some pictures of the final result. I'll post it here when i get it.

Hi Burr

Very nice, good video.

Nice rendering too, is that the Keyshot software as used in Alibre or do you just have the "stand alone" version ? ?

Regards
Rob


.

[BurrMan]

Hey General thanks. Close... It's the new Bunkspeed render engine. So it's powered by iray. Keyshot (luxion) was bunkspeeds old render engine.. They split up and luxion continues dev on their engine. Bunkspeed created a new one. Both are very nice. (I have keyshot too)

[The Engine Guy]

Hey General thanks. Close... It's the new Bunkspeed render engine. So it's powered by iray. Keyshot (luxion) was bunkspeeds old render engine.. They split up and luxion continues dev on their engine. Bunkspeed created a new one. Both are very nice. (I have keyshot too)

You have both ? ? COOL

Regards
Rob


.